SciCan HYDRIM L110w Service Manual download pdf (Page 25)

2. Routine Procedures and Maintenance

2.4 Cleaning the chamber

The HYDRIM L110w G4 chamber can be cleaned using the “Cleaning” program in the User

menu. This cycle is used to periodically remove hardwater deposits from the chamber walls

and racks. Pour 1 litre of vinegar into the chamber before starting the cycle. From the User

menu, select “Cleaning” and a cleaning cycle, similar to a normal wash cycle, will run. The

user will be prompted to clean the chamber every 25 cycles. Reminder frequency can be

changed to 25, 50, or 75 cycles. To do this, enter the Technician menu.

2.5 Draining the unit for service or shipping

To drain the unit prior to shipping, or before tipping it onto its back for servicing, run the

“Prepare for Shipping” cycle. Once complete, drain any water remaining in the air gap using

the silicone tube located under the centre of the unit’s kickplate.

2.6 Upgrading the firmware and themes

NOTE: Instructional videos are available on http://updates.scican.com

NOTE: Upgrading the Interface Software can be done from a USB drive. The easiest and

fastest method is to use a USB drive.

In order to manually upgrade the Interface and Themes software, please follow the steps

below. This process will take approximately 30-35 minutes.

2.6.1 Using a USB drive with the software already loaded onto it

If using a USB drive with the software already loaded onto it, please start at step 3.

Using a blank USB drive

In order to use this method you must already have a zipped ﬁle with the appropriate ﬁles on

your computer. The zipped ﬁle may have been emailed or provided to you.

1. Insert a new or blank (no ﬁles) USB drive into your computer.

2. Save the HYDRIM G4 software upgrade zip ﬁles (SH11MRXXX.zip) to your

USB and extract the ﬁles contained in the zip ﬁles directly to the clean/

blank USB drive.

Once the ﬁles are successfully unzipped to the USB drive, it is ready.

Remove the drive from the computer. DO NOT INSERT the USB drive in to

the Hydrim G4 yet.

3. Power the HYDRIM G4 unit OFF.

4. Insert the USB drive into the USB port located on the front, top,right corner of the unit.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 73 74

No comments

SciCan HYDRIM L110w Service Manual Page 25